XJW-E22G24D-F7** AR (Annovi Reverberi) Pump 2 GPM @ 2400 PSI

**Special F7 for vertical pump

Oil Capacity = 4.5 oz, Maximum Fluid Temperature = 140° F, Inlet Thread = 1/2”M, Discharge Thread = 3/8”M

SPECIAL NOTE: Use only AR64545 (click link to view/purchase oit) for the XJ/SJ/BK Series pumps only: Do NOT change oil. Use oil only to add if low. This oil is a specially formulated synthetic with special additives for the demands of the XJ, SJ and BK pump series. No other oil is factory approved for these pumps, and could result in pump failure.

• MANIFOLD: High strength forged brass for long term use.
• BOLTS: Three 10mm grade 8.8.
• PISTONS: Polished stainless steel for longer pump life in harsh environments.
• CRANKCASE: Precision die-cast, large cooling fins for maximum heat dissipation.
• BEARINGS: Angular contact ball bearing stabilizes the crankshaft and one thrust needle bearing absorbs the plunger load and assure long radial plate life. All of the thrust plates are made of heat treated hardened steel for extended life.
• VALVES, SEATS, AND SPRINGS: Stainless steel with specially designed Ultra Form cages provide extra long life and positive seating.
• SEALS AND V-PACKINGS: Continuously lubricating for extended life.
• UNLOADER: Built in to optimize performance while reducing setup time. Integral trap pressure, fixed or adjustable chemical injector.